C2G Unshielded Snagless Cat6 Ethernet Network Cable - Green - 10ft
| IN STOCK |
C2G Cat6 75ft Snagless Patch Networking Cable - Blue
| IN STOCK |
35ft C2G RJ-45 Male To RJ-45 Male Cat6a Snagless Unshielded Network Patch Ethernet Cable - Green
| IN STOCK |
3FT Tripp Lite Duplex LC Multi Mode To LC Multi Mode Fiber Optic Patch Cable - Red
| IN STOCK |
C2G Snagless Unshielded Cat6 Ethernet Network Cable - Pink - 4ft
| IN STOCK |
Tripp Lite 20FT RJ45 Male Gigabit Snagless Molded Patch Cable - White
| IN STOCK |
C2G Shielded Snagless Cat6 Ethernet Network Patch Cable - Black - 12ft
| IN STOCK |
C2G Cat6 2ft Snagless Unshielded Networking Patch Ethernet Cable - Blue
| IN STOCK |
C2G Cat6 Snagless Shielded 20ft Networking Cable - Red
| IN STOCK |
Tripp Lite 10FT RJ45 Male Cat5e 350MHz Snagless Molded Patch Cable - Black
| IN STOCK |
7FT C2G RJ-45 Male To RJ-45 Male Cat6 Snagless Ethernet Patch Cable - Yellow
| IN STOCK |
Belkin Cat6 3ft Unshielded Networking Cable - Green
| IN STOCK |
C2G Cat6 Snagless Shielded 20ft Networking Cable - Green
| IN STOCK |
Tripp Lite 1.52M Cat6 RJ45 Right Angle to RJ45 Gigabit Molded Patch Cable - Blue
| IN STOCK |
Tripp Lite 0.61M RJ45 Up-Angle Male to RJ45 Down-Angle Male Cat6 Gigabit Molded Slim UTP Ethernet Cable - Blue
| IN STOCK |
Tripp Lites Mode Conditioning Cables are designed for use in Gigabit Ethernet 1000BASE-LX applications. They are fully compliant with IEEE 802.3z application standards. Mode Conditioning Cables are needed in applications where new high-speed Gigabit 1000BASE-LX routers and switches are being deployed into existing multimode plants.
The need for this patch cord is due to the single-mode launch nature of the -LX or long-wave (1300 nm) transceiver modules used for Gigabit Ethernet. Launching a single-mode laser into the center of a multimode fiber can cause multiple signals to be generated that confuses the receiver at the other end of the fiber.
These multiple signals, caused by Differential Mode Delay (DMD) effects, severely limit the cable distance lengths for operating Gigabit Ethernet. A mode conditioning patch cord eliminates these multiple signals by allowing the single-mode launch to be offset away from the center of a multimode fiber.
- Use Singlemode Transceivers on Multimode Fiber Backbones
- Offsets the Singlemode Laser launch from the center of a Multimode fiber
| LENGTH | 2m |
| LEFT CONNECTOR | 2 x SC |
| RIGHT CONNECTOR | 2 x SC |
| COLOR | Yellow, Orange |
| WARRANTY | Lifetime manufacturers warranty |